Battery Use And Safety; To Install Batteries; Wireless Range - GE 45633 User Manual

remote retains all network settings while replacing the batteries,
however, day/date/time settings will need to be re-programmed if
the batteries are left out for more than 3 minutes.

Battery Use and Safety:

• Use only fresh batteries of the required size and recommended
type.
• Do not mix old and new batteries or different types of batteries
• If you do not plan to use the remote for an extended period,
remove the batteries. They can leak chemicals that can destroy
electronic parts.
• Dispose of old batteries promptly and properly. Do not burn or
bury them.
• Replace fully discharged batteries immediately.

To Install Batteries:

1. Open the battery compartment cover by sliding it away from
the remote's body.
2. Note the + and - polarity symbols inside the battery compart-
ment.
3. Insert the batteries, making sure their polarity matches the
symbols in the compartment.
4. Replace the cover.
Controlling Appliances:
Exercise extreme caution when using Z-Wave devices to control appliances.
Operation of the Z-Wave device may be in a different room than the controlled
appliance, also an unintentional activation may occur if the wrong button on the
remote is pressed. Z-Wave devices may automatically be powered on due to
timed event programming. Depending upon the appliance, these unattended or
unintentional operations could possibly result in a hazardous condition. For these
reasons, we recommend the following:
1. Assign Z-Wave controlled appliances to device numbers 10 – 18 on the GE
remote. The likelihood of unintentionally turning on the appliance will be reduced
significantly because the "Shift" button will need to be pressed before pressing
device numbers 10-18.
2. Z-Wave devices controlling appliances should be removed from "All" control
setting. Instructions on how to do this are included in the manual for your GE
remote.
3. Do Not include Z-Wave devices in Groups or Scenes if they control appliances.
4. Do Not use Z-Wave devices to control electric heaters or any other appliances
which may present a hazardous condition due to unattended or unintentional or
automatic power on control.
5. Double check programs for accuracy before using them.
NOT FOR USE WITH MEDICAL OR LIFE SUPPORT EQUIPMENT
Z-Wave enabled devices should never be used to supply power to, or control the
On/Off status of medical and/or life support equipment

WIRELESS RANGE

This device exceeds the Z-Wave standard of open-air, line of sight
WARNING
RISK OF FIRE
RISK OF ELECTRICAL SHOCK
RISK OF BURNS
8