Adding A Light To A Scene; Controlling A Scene; Removing A Light From A Scene - GE 45633 User Manual

Add

Adding a Light to a Scene:

1. Enter SETUP and select SCN SETUP.
2. Press OK. The screen will display ADD.
3. Press OK. The screen will display SEL DIGIT.
4. Press the number key (1-9) for the scene you wish to add the
device to. Press SHIFT and the number key (1-9) if you are add-
ing devices to scenes 10 through 18.
5.Press OK. The screen will display SCENE X and WAITING (the re-
mote will time-out if you have not completed steps 6 - 8 within
30 seconds)
6. Press the button on the device that you are adding.
7. Press and hold the button on the device to adjust the brightness
level. Release the button when the light is at the desired level.
8. Press the OK button on the remote
9. When the screen displays SUCCESS, you have successfully
added the device to a scene.
Please note: Non-dimmable On/Off only lighting devices can be
added to scenes in either On or Off mode so as an example, the
same light could be ON in scene 1 and Off in scene 2. Step 7
above is skipped when adding an On/Off only device to a scene.

Controlling a Scene:

1. Press SCENE once to put the remote in SCENE Mode. The re-
mote will stay in this mode until one of the other modes
is selected.
2. Press the number key for the scene you wish to control (1-9).
Press SHIFT and the number key (1-9) if you are controlling
scenes 10 through 18. The screen will display scene and the
number selected.
• To turn a scene on, press and release the ON key for less than
one second.
• To turn a Scene off, press and release the OFF key for less than
one second.

Removing a Light from a Scene:

This only removes the device from a specific scene. The device is
still part of your home control network and the scene still exists (if
there were more than one device in the scene to start).
1. Enter SETUP and select SCN SETUP.
2 Press OK followed by either arrow key to select REMOVE.
3. Press OK. The screen will display SEL DIGIT.
4. Press a number (1-9) for the scene you wish to remove the de-
vice from. Press SHIFT and the number (1-9) if you are removing
devices from scenes 10 through 18.
SCN SETUP
Remove
15
Delete
Label