Tools Required For Assembly; Unpack Carton - Craftsman 917.203930 Operator's Manual

Mower
(2) Rear
Lift Link _
(5) 1-3/16
Assemblies
O.D. Washers
(1) Small
Retainer Springs
(5) Large
Retainer Springs
(1) Front
Lift Link
Assembly
Mower Front Wheel
(1) Shoulder Bolt
(1) Wheel
©
(1) 1-1/40.D.
Washer
©
(1) 3/8-16
Locknut
if Equipped
(1) Anti-Sway Bar
(1) 3/40.D.
Washers
(1) Srnall Retainer
Springs
Keys
(2) Keys
(1) Oil Drain Tube
(1) Quick Connect
Slope Sheet
Your new tractor has been assembled at the factory with exception of those parts left
unassembled for shipping purposes. To ensure safe and proper operation of your tractor
all parts and hardware you assemble must be tightened securely. Use the correct tools
as necessary to ensure proper tightness.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly
easier. Standard wrench sizes are listed.
TO REMOVE TRACTOR
CARTON
UNPACK CARTON
FROM
(2) 7/16" wrenches Utility knife
(1) 1/2" wrench Tire pressure gauge
(1) 3/4" wrench Pliers
(1) 3/4" socket w/drive ratchet
(1) 9/16" wrench Flashlight
When right or left hand is mentioned in this
manual, itmeans when you are inthe operating
position (seated behind the steering wheel).
• Remove all accessible loose parts and
parts cartons from carton.
• Cut along dotted lines on all four pan-
els of carton. Remove end panels and
lay side panels flat.
• Remove mower and packing materials.
• Check for any additional loose parts or
cartons and remove.
7