Connection Of San And The Internal Hdd/Sdd After Installation - Fujitsu PRIMEQUEST 2000 Series Installation Manual

CHAPTER 4 Installation of Operating System and bundled software
4.3 Procedure to install Windows in SAN/iSCSI storage device
6. Dump area is set.
Confirm that there is sufficient free space on the hard disk before acquiring the memory damp.
For details, see "11.4.3 Settings of dump environment (Windows)" of PRIMEQUEST 2000 series Administration
Manual (CA92344-0537).
7. The management information and configuration information are stored.
For details, see
8. UPS battery monitor is set.
When the duration of life of the UPS battery is monitored: see "Setting for component replacement alert for
PRIMEQUEST ". This document is downloaded from the following URL.
http://www.fujitsu.com/global/products/computing/servers/mission-
critical/primequest/documents/manuals/
9. Watchdog Timer allows reboot OS in case that OS freezes. R
passes,
For details, see "8.4 Automatic Partition Restart Conditions" of PRIMEQUEST 2000 series Administration
Manual (CA92344-0537).

4.3.5 Connection of SAN and the internal HDD/SDD after installation

For SAN and the internal HDD/SDD connection after the completion of installation, see PRIMEQUEST 2000 Series SAN
Boot Environment Configuration Manual.
1. Change and confirm the settings of the detailed information of the FC card.
For details, see PRIMEQUEST 2000 Series SAN Boot Environment Configuration Manual.
2. OneCommand Manager is started. The following driver parameters are set.
For the details of the set value, see San storage device manual.
- Topology
- Queue Depth
- Queue Target
- Link Speed
3. Check the registry information.
For details on the checking method, see PRIMEQUEST 2000 Series SAN Boot Environment Creation Manual.
For details on setting value, see Manual of SAN storage device.
-TimeOutValue
"5.7 Saving management and configuration information".
ebooting OS is executed when the set time
64
CA92344-0536-04