Attach The Msm415 To The Bracket - HP MSM415 Hardware Installation

Mounting Directly on a Wall
1. Respecting the UP indicator on the bracket, hold the bracket against the wall at the desired
position. Mark two holes for the screws (wall anchors) and one hole in the cutout area of the
bracket for the Ethernet cable.
2. Drill two holes for the wall anchors, typically 3/16 inch (4.7 mm) in diameter.
3. Drill a hole for the Ethernet cable. Alternatively, you can feed the Ethernet cable from above
and through the MSM415 cable channel.
4. Insert the anchors and tap them flush with the wall surface.
5. Pull the Ethernet cable through the hole in the wall and the hole in the bracket.
6. Screw the bracket to the wall.
Mounting on a suspended ceiling
The MSM415 can be mounted on a suspended ceiling with user-supplied T-bar clips or the
equivalent. Use a clip stud size of #8-32 (3.5 mm) with a maximum length of 7/16 inch (11mm).
Figure 8. Mounting with T-clips
1. Attach two T-bar clips (not supplied) to the bracket as illustrated. The clips must be attached
to the smooth outer side of the bracket.
2. Attach the bracket to the suspended ceiling T-bar at the desired mounting position.
3. Once the bracket is firmly attached to the T-bar, cut a hole in the ceiling through the bracket
opening for the Ethernet cable.
4. Pull the Ethernet cable through the hole in the bracket.

Attach the MSM415 to the Bracket

1. Connect the Ethernet cable to the MSM415 Ethernet port. Push excess cable back into the hole.
2. Position the MSM415 against the bracket so that the bracket tabs fit into the tab slots on the
back of the MSM415. Push the MSM415 against the bracket and then pull down firmly so that
it snaps onto the bracket.
3. Verify that the MSM415 is firmly anchored before letting go of it.
4. Optionally, secure the MSM415 to an immovable object with a Kensington-type cable lock using
the hole below the status LEDs.
T-bar clip
Smooth
side of
bracket
Hardware Installation
Installing RF Security Sensors
1-13