Table of Contents
Advertisement
Hardware Installation
Installing the RF Manager
2. Hold the RF Manager with attached brackets up to the rack and move it vertically until rack
holes line up with the bracket holes, then insert and tighten the four number 12-24 screws to
secure the brackets to the rack.
Figure 4. RF Manager rack-mount example
Horizontal Surface Mounting
Place the RF Manager on a table or other horizontal surface. The RF Manager comes with rubber
feet in the accessory kit that can be used to help keep it from sliding on the surface.
Attach the rubber feet to the four corners on the bottom of the RF Manager within the embossed
angled lines. Use a sturdy surface in an uncluttered area. You may want to secure the networking
cables and the power cord to a table leg or other part of the surface structure to help prevent tripping
over the cords.
Caution
Make sure the air flow is not restricted around the sides and back of the RF Manager.
1-8
Advertisement
Table of Contents
