Sony ICP-6530 Installation Manual page 27

D1804 (F-4): POR MON LED 3
CA-86 board status indication.
Lit when LED 2 is lit, IC2001 operates normally, and HW
Reset to CPU is cancelled.
* All of the POR MON LED 0 to 3 are lit during normal
operation.
D2301 (E-7): PANEL IF LED 0
Lit when link-up of PCI Express between IC001 and
IC2001 is completed.
D2302 (F-7): PANEL IF LED 1
Lit when the transmission Clock to the KY board is output
normally.
D2303 (F-7): PANEL IF LED 2
Lit when the power supply to the KY board is started and
Reset is cancelled.
D2304 (F-7): PANEL IF LED 3
Lit when the data reception from the KY board can be
performed correctly.
* All of the PANEL IF LED 0 to 3 are lit during normal
operation.
Switch
S1801 (A-2): SETTING
Sets the initial configuration of the CA-86 board.
Setting of bit [2:1]: boot rom location.
00 = NAND
01 = SD card
10, 11 = reserved
bit [8:3]: engineering use
* Do not change the setting.
S1802 (G-5): RECONF
Performs the forced shutdown of the CA-86 board.
S1904 (A-1): RESET
Issues the hardware reset to the CA-86 board.
S1905 (F-6): SRESET
Issues the software reset to the CA-86 board.
ICP-6520/6530/3000/6511
1-21 (E)