Table of Contents
Advertisement
Carephone 62
6.2.3
Key functions during keyboard programming
The following key functions can be used at any time.
C
Save new settings and go to the next programming step.
Settings that are not confirmed with C will not be saved!
A
The setting of the programming step is erased.
*
Return to the beginning of the programming mode.
The Carephone 62 announces "Selection".
**
Terminate programming. The Carephone 62 announces: "Setup
ended". Programming also terminates automatically if no entries
are made for 10 minutes.
0 to 9 Enter the programming data.
P
The Carephone 62 announces the programming step's number and
current setting.
R
Reset the Carephone 62. It will then emit a beep. All pending
alarms/calls are cancelled and the Carephone 62 reboots.
6.2.4
Programming steps
Programming the Carephone 62 consists of individual steps,
numbered 01 to 99. A programming step consists of a number
and an associated setting. Press the number of the step that
you want to access.
01 Language selection
When the Carephone 62 is powered on, it announces different languages:
–
1 = German, 2 = Dutch, 3 = French, 4 = English, 5 = Spanish,
0 = synthetic speech disabled. There is no default setting.
03 Radio jamming
The Carephone 62 sends a technical message to the monitoring centre
when a radio signal from another device disturbs it.
–
0 = off, 1 = on. Default value is 0.
05 RB2000 & RB2000E alternative connection
It is possible to change the connection mode for the RB2000 and RB2000E
protocols. 0 = normal connection, 1 = alternative connection. Check the
compatibility with your alarm receiving center. Default value is 0.
TeleAlarm
User Manual
Programming | en
F.01U.141.162 | V6 | 2015.04
23
Advertisement
Table of Contents
