Pioneer SW-8 Operation Manual

Pioneer SW-8 Operation Manual

Powered subwoofer
Hide thumbs Also See for SW-8:

Advertisement

Available languages

Available languages

Quick Links

The lightning flash with arrowhead
symbol, within an equilateral
TO PREVENT THE RISK OF
triangle, is intended to alert the
ELECTRIC SHOCK, DO NOT
user to the presence of uninsulated
REMOVE COVER (OR BACK).
"dangerous voltage" within the
NO USER-SERVICEABLE
product's enclosure that may be of
PARTS INSIDE. REFER
sufficient magnitude to constitute a
SERVICING TO QUALIFIED
risk of electric shock to persons.
SERVICE PERSONNEL.
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with dry cloth.
7. Do not block any ventilation openings.
Install in accordance with the manufacturer's
instructions.
8. Do not install near any heat sources such
as radiators, heat registers, stoves, or other
apparatus (including amplifiers) that
produce heat.
9. Do not defeat the safety purpose of the
polarized or grounding-type plug. A polarized
plug has two blades with one wider than
the other. A grounding type plug has two
blades and a third grounding prong. The
wide blade or the third prong are provided
for your safety. If the provided plug does not
fit into your outlet, consult an electrician for
replacement of the obsolete outlet.
10. Protect the power cord from being walked on
or pinched particularly at plugs, convenience
receptacles, and the point where they exit
from the apparatus.
.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
The exclamation point within
an equilateral triangle is
intended to alert the user to
the presence of important
operating and maintenance
(servicing) instructions in
the literature accompanying
the appliance.
11. Only use attachments/accessories specified
by the manufacturer.
12. Use only with the cart, stand, tripod, bracket,
or table specified by the manufacturer, or
sold with the apparatus. When a cart is used,
use caution when moving the cart/apparatus
combination to avoid injury from tip-over.
13. Unplug this apparatus during lightning
storms or when unused for long periods
of time.
14. Refer all servicing to qualified service
personnel. Servicing is required when
the apparatus has been damaged in any
way, such as power-supply cord or plug
is damaged, liquid has been spilled or
objects have fallen into the apparatus,
the apparatus has been exposed to rain or
moisture, does not operate normally, or has
been dropped.
Handle the power cord by the plug. Do not pull
out the plug by tugging the cord and never touch
the power cord when your hands are wet as this
could cause a short circuit or electric shock. Do
not place the unit, a piece of furniture, etc., on the
power cord, or pinch the cord. Never make a knot
in the cord or tie it with other cords. The power
cords should be routed such that they are not
likely to be stepped on. A damaged power cord
can cause a fire or give you an electrical shock.
Check the power cord once in a while. When
you find it damaged, ask your nearest PIONEER
authorized service center or your dealer for a
replacement.
Before plugging in for the first time, read the
following section carefully.
If the AC plug of this unit does not match
the AC outlet you want to use, the plug must
be removed and appropriate one fitted.
Replacement and mounting of an AC plug on
the power supply cord of this unit should be
performed only by qualified service personnel.
If connected to an AC outlet, the cut-off plug
can cause severe electrical shock. Make
sure it is properly disposed of after removal.
The equipment should be disconnected by
removing the mains plug from the wall socket
when left unused for a long period of time (for
example, when on vacation).
The POWER switch on this unit will not completely
shut off all power from the AC outlet. Since the
power cord serves as the main disconnect
device for the unit, you will need to unplug it from
the AC outlet to shut down all power. Therefore,
make sure the unit has been installed so that the
power cord can be easily unplugged from the AC
outlet in case of an accident. To avoid fire hazard,
the power cord should also be unplugged from
the AC outlet when left unused for a long period
of time (for example, when on vacation).
This product is for general household purposes.
Any failure due to use for other than household
purposes (such as long-term use for business
purposes in a restaurant or use in a car or ship)
and which requires repair will be charged for
even during the warranty period.
Handling the cord on this product
or cords associated with accessories sold
with the product may expose you to chemicals
listed on proposition 65 known to the State
of California and other governmental entities
to cause cancer and birth defect or other
reproductive harm.
Operating environment temperature and humidity:
+5 °C to +35 °C (+41 °F to +95 °F); less than 85
%RH (cooling vents not blocked) Do not install
this unit in a poorly ventilated area, or in locations
exposed to high humidity or direct sunlight (or
strong artificial light)

Advertisement

Table of Contents
loading

Summary of Contents for Pioneer SW-8

  • Page 1 fire or give you an electrical shock. reproductive harm. Check the power cord once in a while. When you find it damaged, ask your nearest PIONEER authorized service center or your dealer for a Operating environment temperature and humidity: replacement.
  • Page 2 finish. NOTE: Please retain the carton and packing material for your Pioneer products, to protect them in the event of a move or if they need to be shipped to a service center. Product received damaged by a service center that has been shipped by the end user in other than the original packaging will be repaired, refurbished and properly packaged for return shipment, at the end user’s expense.
  • Page 3 www.pioneerelectronics.com STATUS INDICATOR – The LED found on the front panel will illuminate when the subwoofer is functioning. If the unit is in Auto mode and is not receiving a signal, the light will remain off. VOLUME – This knob can be adjusted to control the level of output from your subwoofer. The level chosen should allow the subwoofer to blend its output with that of the rest of your audio system.
  • Page 4 www.pioneerelectronics.com All power should be turned off to your system before any connections are made. Careful at- tention should be taken to ensure that all electronic components are not connected to an AC source. Not doing so could result in potential damage to the system. RCA –...
  • Page 5 www.pioneerelectronics.com 1. After having turned on the main power switch and having broken-in the speaker, select the correct posi- tion for the POWER, either On or Auto depending on your system. The Auto selection will leave the unit in a self-sensing mode, such that should the unit sense an audio signal it will turn itself on and then shut down after several minutes without signal, while in the On position the subwoofer always remains on.
  • Page 6 www.pioneerelectronics.com 38 Hz - 150 Hz 12-3/16" x 14-3/16" x 12-3/16" 20 lbs 4 oz 8" 100 W 1.0 A 120 V / 60 Hz...
  • Page 7 Authorized Service Company, please call or write: PIONEER ELECTRONICS (USA), INC. PIONEER ELECTRONICS OF CANADA, INC. P.O. BOX 1760, LONG BEACH, CALIFORNIA 90801 300 ALLSTATE PARKWAY, MARKHAM, ON L3R 0P2 (905) 479-4411 • 1-877-283-5901 • http://www.pioneerelectronics.ca 1-800-421-1404 •...
  • Page 8 300 Allstate Parkway Markham, Ontario L3R OP2, Canada Blvd. Manuel Avila Camacho 138 piso 10 Col. Lomas de Chapultepec 11000 Delegacion Miguel Hidalgo Mexico, D.F. Published by Pioneer Electronics (USA) Inc. Copyright © 2010 Pioneer Electronics (USA) Inc. All rights reserved Printed in China...
  • Page 9 Si votre cordon est endommagé, faites-le remplacer chez votre détaillant ou chez Température et humidité relative de votre centre de service PIONEER le plus près. l’environnement d’utilisation : +5 °C à +35 °C (+41 °F à +95 °F); humidité relative inférieure à...
  • Page 10 éliminer la poussière ou les traces de doigts. N’utilisez ni essuie-tout ni matériau abrasif et ce, pour ne pas endommager le fini. REMARQUE : Veuillez conserver le carton et le matériel d’emballage de vos produits Pioneer afin de les protéger dans le cas d’un déménagement ou s’ils doivent être expédiés à un centre de service. Tout produ- it endommagé...
  • Page 11 www.pioneerelectronics.com VOYANT D’ÉTAT – La DEL figurant sur le panneau avant s’allume lorsque le subwoofer est en marche. Si l’unité est en mode Auto et qu’elle ne reçoit pas de signal, le voyant reste éteint. VOLUME – Ce bouton peut être ajusté pour contrôler le niveau de sortie de votre subwoofer. Le niveau sélectionné...
  • Page 12 www.pioneerelectronics.com Toute l’alimentation doit être coupée à votre système avant d’effectuer toute connexion. Faites particulièrement attention pour vous assurer que tous les composantes électroniques ne sont pas connectées à une source secteur. Ne pas le faire pourrait éventuellement endommager le système. RCA –...
  • Page 13 www.pioneerelectronics.com 1. Après avoir mis le commutateur d’alimentation principale et après avoir rôdé l’enceinte, sélectionnez la position correcte pour le ALIMENTATION, soit sur On soit sur Auto en fonction de votre système. La sélection Auto laisse l’unité en mode auto-détecteur de sorte que, si l’unité détecte un signal audio, elle s’allume automatiquement et s’éteint au bout de quelques minutes sans signal, tandis que dans la position On, le subwoofer reste toujours allumé.
  • Page 14 www.pioneerelectronics.com 38 Hz -150 Hz 310 mm x 361 mm x 310 mm 9,20 kg 20 cm 100 W 1,0 A 120 V / 60 Hz...
  • Page 15 PIONEER ELECTRONICS (USA), INC. PIONEER ÉLECTRONIQUES DU CANADA, INC. P.O. BOX 1760, LONG BEACH, CALIFORNIA 90801 300 ALLSTATE PARKWAY, MARKHAM, ON L3R 0P2 1-800-421-1404 • http://www.pioneerelectronics.com (905) 479-4411 • 1-877-283-5901 • http://www.pioneerelectronics.ca ENREGISTREZ LE LIEU ET LA DATE D’ACHAT POUR RÉFÉRENCE ULTÉRIEURE No.
  • Page 16 300 Allstate Parkway Markham, Ontario L3R OP2, Canada Blvd. Manuel Avila Camacho 138 piso 10 Col. Lomas de Chapultepec 11000 Delegacion Miguel Hidalgo Mexico, D.F. Publié par Pioneer Electronics (USA) Inc. Copyright © 2010 Pioneer Electronics (USA) Inc. Tous droits réservés Imprimé en Chine...
  • Page 17 Si detecta u otros daños del aparato reproductor. daños, solicite al centro de servicio autorizado PIONEER más cercano o al concesionario que se lo reemplace. Temperatura y humedad del entorno de func- ionamiento: +5 °C a +35 °C (+41 °F a +95 °F);...
  • Page 18 NOTA: Por favor guarde la caja y los materiales de embalaje de sus productos Pioneer, a fin de prote- gerlos en caso de mudanza o si es necesario enviarlos a un centro de servicio. Un producto que se recibe dañado en un centro de servicio, y que el usuario final envía en un embalaje que no es el original, será...
  • Page 19 www.pioneerelectronics.com INDICADOR DE ESTADO – El indicador LED ubicado en el panel frontal se ilumina cuando el subwoofer está funcionando. Si la unidad está en el modo Auto y no está recibiendo señal, la luz permanecerá apagada. VOLUMEN – Esta perilla puede ajustarse para controlar el nivel de salida de su subwoofer. El nivel elegido debe permitir al subwoofer amalgamar su salida con la del resto del sistema de audio.
  • Page 20 www.pioneerelectronics.com Antes de hacer conexiones, el sistema debe estar totalmente desconectado de la corriente. Se debe prestar mucha atención para asegurar que ninguno de los componentes electrónicos esté conectado a una fuente de corriente alterna. De no hacerse esto, el sistema podría sufrir daños. RCA –...
  • Page 21 www.pioneerelectronics.com 1. Una vez que haya encendido el interruptor principal de alimentación y probado la bocina, seleccione la posición correcta para el INTERRUPTOR PRINCIPAL, o bien On o Auto, dependiendo del sistema. La opción Auto dejará la unidad en el modo autosensor, con lo cual, si la unidad detecta una señal de audio, se encenderá...
  • Page 22 www.pioneerelectronics.com 38 Hz -150 Hz 310 mm x 361 mm x 310 mm 9,20 kg 20 cm 100 W 1,0 A 120 V / 60 Hz...
  • Page 23 Para la conexión e instalación de su unidad, o para localizar una Compañía de Servicio Autorizada, llame o escriba a: PIONEER ELECTRONICS (USA), INC. P.O. BOX 1760, LONG BEACH, CALIFORNIA 90801 1-800-421-1404 • http://www.pioneerelectronics.com ANOTE EL LUGAR Y FECHA DE COMPRA PARA REFERENCIA FUTURA Modelo No.
  • Page 24 300 Allstate Parkway Markham, Ontario L3R OP2, Canada Blvd. Manuel Ávila Camacho 138 piso 10 Col. Lomas de Chapultepec 11000 Delegación Miguel Hidalgo México, D.F. Publicado por Pioneer Electronics (USA) Inc. Copyright © 2010 Pioneer Electronics (USA) Inc. Todos los derechos reservados. Impreso en China...

Table of Contents