1.2.3
For the SGY-PM910HL/HR/(HL+HR)/H2 with a SGX- CA500
Pedaling MonitorMode:
1. [3.1Temporarily affix the Magnet]: Attach the left and right magnet(s) to the frame temporarily.
2. [2.1 Mode Switching]: Switch to Pedaling Monitor Mode.
Using a SGX-CA500 with Firmware of Version 20150501.02.43 or higher, input the device number of either or both
sensors and switch the mode to Pedaling Monitor Mode. Once this is successful, the Sensor LED will light in
Green
for ten seconds.
3. [3.3.3Fixing the Magnets]: Fix the magnet in place
4. [3.3.4Magnet Calibration]: Carry out Magnet Calibration.
5. [4 Pairing]: Pair the sensors with the cycle computer using the Pedaling Settings Menu in the SGX-CA500.
6. [5Zero Calibration]: :Carry out Zero Calibration.
7. [6Copy pedal]:If using only one sensor SGY-PM910HL/HR; Set up the Pedal Copy function on the
SGX-CA500.
8. [7Operation Check]
5