Download Print this page

Before Use - Hitachi CM-N10000 Instructions Manual

Ion cleansing with moisturizing and cooling support device

Advertisement

Do not alter disassemble or repair by unauthorized techinician.
(Cause of fire, electric shock, injury, or failure)
Disassembly
prohibited
Check the head for any damage or deformation before use.
(Cause of skin damage)
Do not use this product together with other beauty treatment devices at the
same time. (Cause of failure or trouble)
Do not use this product if there is some injury or wound to your skin.
(Cause of skin trouble or pain)
Do not drop this product or give it a strong impact.
Prohibited
(Cause of injury or failure)
Do not wipe with benzene, thinner or alcohol, and do not spray insecticide.
(Cause of cracking, electric shock, or ignition)
Use only the attached power adaptor. And, do not use any other product
with the attached power adaptor. (Possibility of electric shock or ignition)
Remove accessories such as earrings and necklaces, and contact lenses
before use. (Cause of accident or trouble)
If there is any severe skin disorder or irregularity on your skin surface, or due
to downy hair, you may feel strong irritation in rare instances. In this case,
avoid using this product on that region. (Cause of accident or trouble)
Make sure
Do not keep the cotton puff or the head on one part of your skin but always
keep it in motion. (Cause of skin trouble or poor physical condition)
Do not hold the cord to pull out the power plug and device plug.
(Cause of disconnection, electric shock, short circuit, or ignition)
Make sure to pull out the power plug from the outlet while not in use.
(Cause of electric shock or fire by deterioration)
Unplug
Names of parts and their functions (Fig. 1)
Head (titanium material)
Set a cotton puff and apply it to the skin.
This section vibrates during use in modes
except "COOL-AESTHETIC" mode.
Mode indicator lamp (orange)
Mode
During preparation
During use
CLEANSING
Orange flashes
Orange lights
MICRO-PAT
MOISTURIZE
COOL-AESTHETIC
Blue flashes
Blue lights
"MODE" selector button
Every time this button is pressed, the
mode is switched.
Side plate
Power switch ("
")
Press this switch to turn on the "LOW"
level indicator lamp lights.
Press this switch again to turn off.
Equipped with an auto-off function, it will
automatically turn "OFF" if the device is
not used for about 30 seconds in an
"ON" state.
Body
Body socket
Level indicator lamps
"HIGH" (red) : "LOW" (green)
When the power switch is turned "ON,"
"LOW" lights. It does not light in the
"COOL-AESTHETIC" mode.
High/low selector button
Every time this button is pressed, the
power level is switched between
"HIGH" and "LOW." The vibration power
does not change.
Side plate
Touch this part and apply the head to
your skin, and the device will start to
operate in modes except
"COOL-AESTHETIC" mode.

Before use

When sensing anything unusual with your skin or body during
use, immediately stop using this product and consult a
dermatologist. (Cause of an accident or poor physical condition)
Remove accessories and contact lenses.
(Cause of skin trouble or poor physical condition)
1. About mode selection
Step
Mode
"CLEANSING" (Pulls out fine dirt
remaining in pores.)
"MICRO-PAT" (Optimize skin
condition for moisturizing
ingredient to penetrate easily.)
"MOISTURIZE"
(Allow the toner lotion to penetrate
into cornfield layer of skin.)
"COOL-AESTHETIC"
(To tighten the pores of your skin
by the cooling effect)
Exhaust hole (back)
Cooling fan (built-in)
This operates in the "COOL-AESTHETIC"
mode.
Buzzer (selecting sound/ready sound/
warning sound/ending sound)
Every time the switch/button is pressed,
a selecting sound can be heard.
At ready in the "COOL-AESTHETIC"
mode, a ready sound can be heard. If a
warning sound can be heard during use,
it is a signal to indicate a device failure.
When each mode ends, an ending sound
can be heard. When each mode exits, an
ending sound can be heard.
Power adaptor Model: KH-186B
Power plug
Insert in an outlet to the roots.
Device plug
Cord
Accessories
Rings (two)
Rings for fixing a cotton puff.
Cotton puff and cosmetics
Apply your regular toner onto a new cotton
and use.
Apply your regular toner onto the skin and
use.
No cotton required.
Apply your regular onto a new cotton and use.
Pat your skin with the head directly.
Do not use toner.

Advertisement

loading