11
SERVICE WORK ON THE CHASSIS
11.1
Raising the motorcycle with the lift stand
11.2
Removing the motorcycle from the lift stand
Note
Danger of damage The parked vehicle may roll away or fall over.
–
Always place the vehicle on a firm and even surface.
0 0 1
11.3
Bleeding the fork legs
1
11.4
Cleaning the dust boots of the fork legs
–
Raise the motorcycle at the frame below the engine.
The wheels should no longer touch the ground.
–
Secure the motorcycle against falling over.
Lift stand (54829055000)
401942-01
–
Remove the motorcycle from the lift stand.
–
Remove the lift stand.
–
To park the motorcycle, insert plug-in stand
dle.
Info
Remove the plug-in stand before riding.
402001-10
Preparatory work
–
Raise the motorcycle with the lift stand. (
Main work
–
Release bleeder screws
Any excess pressure escapes from the interior of the fork.
–
Tighten the bleeder screws.
L01910-10
Finishing work
–
Remove the motorcycle from the lift stand. (
Preparatory work
–
Raise the motorcycle with the lift stand. (
–
Loosen the fork protection. (
Main work
–
Push dust boots
Info
The dust boots remove dust and coarse dirt particles from the inside fork
tubes. Over time, dirt can penetrate behind the dust boots. If this dirt is not
removed, the oil seals behind can start to leak.
B00297-10
1
p. 33)
1
.
p. 33)
p. 34)
1
of both fork legs downwards.
into the left side of the wheel spin-
p. 33)
33