Service Note; Disc Removal Procedure If The Tray Cannot Be Ejected (Forced Ejection); Installation Method Of Earth Spring (Front); Installation Method Of Rear Gasket - Sony BDP-S300 Service Manual

1. DISC REMOVAL PROCEDURE IF THE TRAY CANNOT BE EJECTED (FORCED EJECTION)

1. Remove the upper case. (Refer to page 2-1)
2. Insert a clip in the hole of a drive and open a tray.

2. INSTALLATION METHOD OF EARTH SPRING (FRONT)

1. Please install earth spring (front) at an installation position of right and left in a front frame.
Please be careful to directions of installation.
2. Please fix by for each one place with a screw.

3. INSTALLATION METHOD OF REAR GASKET

1. Please remove a rear panel fixed screw and jack fixed screw (total 9 screws) and remove a rear panel.
2. Please stick a rear gasket inside the lower part of a rear panel. Refer to a lower picture. The location of the gasket is between the
optical terminal and the audio terminal.
3. Please install a rear panel in the chassis from the slanting bottom and install a removed screws.

SERVICE NOTE

tray
earth spring (front)
rear gasket
– 4 –
clip