Table of Contents
Advertisement
D-VM1
Note: If you are going to repair the monitor unit.
Do not touch the inverter unit and piezo-electric transformer that
are mounted on the TFT board both in the statuses of power-on and
power-off.
(Touching these components may damage them.)
piezo-electric transformer
TFT BOARD
MONITOR UNIT
4
SECTION 1
SERVICING NOTE
INVERTER UNIT
NOTES ON HANDLING THE OPTICAL PICK-UP
BLOCK OR BASE UNIT
The laser diode in the optical pick-up block may suffer electrostatic
breakdown because of the potential difference generated by the
charged electrostatic load, etc. on clothing and the human body.
During repair, pay attention to electrostatic breakdown and also use
the procedure in the printed matter which is included in the repair
parts.
The flexible board is easily damaged and should be handled with
care.
NOTES ON LASER DIODE EMISSION CHECK
The laser beam on this model is concentrated so as to be focused on
the disc reflective surface by the objective lens in the optical pick-
up block. Therefore, when checking the laser diode emission,
observe from more than 30 cm away from the objective lens.
Advertisement
Table of Contents
