Radio Frequency Interference; Fcc Requirements - Samsung DCS 400SI User Manual

Hide thumbs Also See for DCS 400SI:
Table of Contents

Advertisement

PART 5. GENERAL USER INFORMATION

5.1 RADIO FREQUENCY INTERFERENCE

WARNING: This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is oper-
ated in a commercial environment. This equipment generates, uses and can radiate radio
frequency energy. If not installed and operated in accordance with the instruction manual,
it may cause interference with radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case the user will be re-
quired to correct the interference at his own expense.
The following measures can be tried:
1. Reorient the receiving antenna.
2. Relocate the telephone with respect to the receiver.
3. Move the telephone equipment away from the receiver.
4. Plug the Key Service Unit into a different AC outlet so that the KSU and receiver are on
different circuits.

5.2 FCC REQUIREMENTS

The DCS 400si electronic telephone system complies with Part 68 of the Federal Commu-
nications Commission Rules and Regulations. On the side of the 400si cover and on the
inside left hand side of the each cabinet is a label that contains, among other information,
the FCC registration number and ringer equivalence number (REN) for the DCS 400si. If
requested, this information must be provided to the telephone company.
UNAUTHORIZED MODIFICATIONS
Any changes or modifications performed on this equipment that are not expressly ap-
proved in writing by SAMSUNG TELECOMMUNICATIONS AMERICA could cause non-
compliance with the FCC rules and void the user's authority to operate the equipment.
NOTE: Allowing this equipment to be operated in such a manner as to not provide for
proper answer supervision is a violation of Part 68 of the FCC's rules.
NOTIFICATION TO TELEPHONE COMPANY
Before connecting the DCS 400si system to the telephone network, the telephone com-
pany may request the following information:
a. Your telephone number or all numbers that will be connected to the DCS 400si.
b. FCC Registration Numbers:
Fully Protected Multifunction Systems
l
Fully Protected PBX's
l
Fully Protected Key Telephone Systems
l
A3LKOR-25495-MF-E
A3KLOR-25260-PF-E
A3KLOR-25496-KF-E
5.1
CONTENTS

Advertisement

Table of Contents
loading

Table of Contents