Samsung DCS 400SI User Manual page 36

Hide thumbs Also See for DCS 400SI:
Table of Contents

Advertisement

tone. The tone is repeated at a programmable interval. Keysets receive an off-hook
ring signal through the speaker and single line stations receive a tone in the hand-
set. The volume of the camp-on tone can be set by the station user. Camped-on
calls follow Forward No Answer if a Forward No Answer destination has been set.
Optionally any station can be programmed to automatically camp-on to a busy
station instead of having to press the camp-on button or dial a camp-on code.
CENTREX/PBX USE
CENTREX and PBX lines can be installed in lieu of central office trunks. CENTREX
and PBX feature access codes including the command for hook-flash (FLASH) can
be stored under one touch buttons. Toll restriction programming can ignore PBX or
CENTREX access codes so that toll calls can be controlled when using these ser-
vices.
CHAIN DIALING
Keyset users may manually dial additional digits following a speed dial call or chain
together as many speed dial numbers as are required.
CLASS OF SERVICE
The system allows a maximum of 30 station classes of service. Each class of
service can be customized in memory to allow or deny access to features and to
define a station's dialing class. Each station can be assigned different classes of
service for day and night operation.
COMMON BELL CONTROL
The DCCP card provides two relays to control a customer-provided common bell or
common audible device. These contacts must be programmed as members of a
station group and may provide steady or interrupted closure.
CONFERENCE
The system allows six simultaneous conferences up to 5 parties each.
ADD-ON (5 PARTY)
Any combination of up to five parties (stations or outside lines) can be joined to-
gether in an add-on conference. Parties may be eliminated or added after a confer-
ence has been established. *Requires D4SWD to provide gain control when 3 or
more trunks are in the conference.
UNSUPERVISED
A station user may set up a conference with two or more outside lines and then exit
the conference leaving the outside lines connected in an unsupervised (trunk to
trunk) conference.
SPLIT
A keyset user can "split" a conference into separate outside calls, then speak with
each caller privately. Then the individual calls can be conferenced again in any
combination.
4.1.8
CONTENTS

Advertisement

Table of Contents
loading

Table of Contents