Panasonic KX-NCP500 Feature Manual page 35

•
To receive Caller ID information, you must subscribe to the telephone company's Caller ID service and
enable Caller ID for the appropriate CO line through system programming.
Caller ID to SLT Port:
Caller ID information can also be shown on a single line telephone (SLT) display. This feature is available only
for SLTs compatible with FSK-type Caller ID.
1.
Caller ID Features
There are three features which can receive Caller ID information. The available feature depends on the
type of CO line receiving the call.
Feature
Caller ID
Calling Line Identification
Presentation (CLIP)
Automatic Number
Identification (ANI)
2.
Caller ID-Related Features
Feature
Calling Line Identification
(CLI) Distribution
Incoming Call Log
3.
Automatic Caller ID Number Modification
When a call is received, the PBX can automatically modify the caller's telephone number according to a
preprogrammed set of rules (Caller ID Modification Table). This modified number will be automatically
stored in the extension's Incoming Call Log, allowing the extension user to make a call to this number later
without worrying about CO Line Access numbers, area codes, etc.
Each trunk group can be assigned a modification table. Each table has ten formulas for modifying local/
international numbers, and one formula for modifying long distance numbers. When a call is received, the
PBX compares the received telephone number to the area codes programmed under "Local/International
Call Data" first. If a match is not found, the telephone number will be modified according to the method
programmed under "Long Distance Code".
Document Version 2013-05
Description
Receives caller information sent from the
telephone company over analog CO lines.
Receives caller information sent from the
telephone company over ISDN lines.
Receives caller information sent from the
telephone company over T1 lines.
Description
Caller ID information received by the PBX is used
to direct calls from specific callers to specific
destinations. The caller's telephone number and a
destination must be assigned in the System Speed
Dialing Table.
Caller information is automatically recorded in the
call log of the extension which received the call.
This information can be used to view a record of
incoming calls or make calls to any number in the
call log.
3.1.3 Caller ID
Details in
–
–
® 17.1.1 T1
Line Service
Details in
® 3.1.15 CLI
(Calling Line
Identification)
Distribution
® 3.1.6 Call
Log, Incoming
Feature Manual 35