Table of Contents
Advertisement
Frequently asked questions
Problem
In the burner display
the symbol will flash
alternately with the
selected power setting
or .
After the cooktop is
turned on, appears in
the display for a few
seconds.
After switching the
cooktop on, .
appears in the display
for several seconds.
The burners do not heat
up.
A burner switches itself
off automatically.
The booster has
automatically switched
off early.
The burner is not
working in the usual
way with the set power
level.
Power setting 9 is
automatically reduced if
you select power
setting 9 on two linked
burners or extended
zones at the same time.
AutoBoost is turned on,
but the food does not
start cooking.
134
Possible cause and solution
There is no or unsuitable cookware on the burner.
Use a suitable pan (see "Pans").
The system lock has been activated.
Deactivate the system lock (see "Cooktop safety
features").
Demonstration mode is activated.
Turn the knob for the front left burner to the left
and hold it.
Turn the knob for the front right burner twice
quickly to the left and then to the left until
appears in the display.
A burner might have been operated for too long.
You can use the burner again by switching it back
on (see "Safety switch-off").
The overheat protection was triggered.
See "Overheat protection".
The overheat protection was triggered.
See "Overheat protection".
Operating both zones at power level 9 would exceed
the permitted maximum power for the cooktop.
Use another burner that is not linked.
Large amounts of food are being heated.
Start cooking at the highest power level, then
reduce the power level manually.
The pan is not conducting heat properly.
Use a different pan that is able to better conduct
heat on an induction cooktop.
Advertisement
Table of Contents
