Lcd - Yamaha DM1000 Service Manual

27.

LCD

(Time required: About 10 minutes)
27-1. Remove the SP1000. (See procedure 1.)
27-2. Remove the MB1000. (See procedure 2.)
27-3. Fasten the control panel assembly. (See procedure 3.)
27-4. Remove the LCD shield plate. (See procedure 24-4.)
27-5. Remove the PN1 (2/4 meter) circuit board.
(See procedure 25-7.)
27-6. Remove the four (4) screws marked [80]. The LCD
can then be removed. (Photo.17)
When you install the LCD shield plate, be sure to
put the four (4) places marked [F] of the LCD
shield plate into the slot of the LCD case.
(Photo.16, 18)
<Bottom view>
[120B]
LCD shield film
[120B]: Bind Head Tapping Screw-B
[170]: Bind Head Tapping Screw-B
<Bottom view>
[80]
[80]: Bind Head Tapping Screw-B
[170]
3.0X8 MFZN2BL (EP600190)
3.0X8 MFZN2BL (EP600190)
Photo.15
[80]
LCD
2.6X6 MFZN2BL (V8927300)
Photo.17
<Bottom view>
PN1 2/4
[120C]: Bind Head Tapping Screw-B
[80]
DM1000/MB1000/SP1000
LCD shield plate
LCD
[120C] [F] (four (4) places)
Photo.16
Photo.18
3.0X8 MFZN2BL (EP600190)
43