Table of Contents
Advertisement
20
To modify configuration parameters use the MPS tool as shown next:
•
Select Display as a device to be programmed.
•
Select a type of the display (Primary or Secondary).
•
Click on Read from Display to read the codeplug parameters. If your device is
successfully read, you will see a list of parameters.
CAUTION: Incorrect configuration can make the device unworkable. Please, make
sure to acquire the appropriate codeplug. Always make a backup copy in case you
have made a mistake during the update.
•
Click on Save to File to backup the original codeplug data.
•
Modify a parameter per your selection.
•
Click on Write to Display to program the device and wait for a confirmation of
successful programming completion.
NOTE: Codeplug has a checksum calculated from its content. Prior to programming the
MPS checks data integrity to protect the device from programming of corrupted data. For
details refer to Maintenance Programming Software User's Manual.
6802982C85-C
Advertisement
Table of Contents
