Setting The Clock - KitchenAid KERC507 Use And Care Manual

U
sing and
Display/clock
• When you first plug in the range, a tone
will sound and the display will show
"88:88." If, after you set the clock, (see the
"Setting the clock" section) the display
again shows "88:88," your electricity was
off for a while. Reset the clock.
• The time display will show "Err" and three
short tones will sound if a time or tempera-
ture is incorrectly entered.
Starting an operation
START
ENTER
After programming a function, you must
press START/ENTER to start the function. If
you do not press START/ENTER within 5
seconds of programming, "START?" will
show in the display as a reminder.
Canceling an operation
CANCEL
OFF
CANCEL/OFF will cancel any function,
except for the Clock Set and Kitchen Timer
functions. When you press CANCEL/OFF,
the large display will show the time of day.

Setting the clock

1. Choose CLOCK SET.
2. Set time.
Example:
PRESS
3
3. Start clock.
PRESS
18
C Y
aring for
PRESS
CLOCK
SET
3 0
START
ENTER
Oven
our
Changing audible signals
Audible signals tell you if a function is entered
correctly or not. They also tell you when a
cycle is completed.
To shut off audible signals during
programming:
PRESS
and hold
for 4
seconds
To shut off all signals except for the
end-of-timer tone:
PRESS
and hold
for 4
seconds
To change the end-of-timer tone to a
4-second tone:
PRESS
and hold
for 4
seconds
A short tone will sound to tell you the signals
have been changed. Repeat step above to
turn the signals back on.
Example:
YOU SEE
CLEAN
Example:
YOU SEE
If the time has not been entered correctly,
three short tones will sound and "Err" is
displayed for 1 second. The previous
display then reappears. Repeat Steps 1,
2, and 3 to re-enter the time of day.
START
TIME
STOP
TIME
SET
•MIN
••HR
HR MIN MIN SEC
START STOP TIME
HR MIN MIN SEC
CLEAN START STOP TIME