Configure The Settings Relating To The Ntp Server [Ntp] - Panasonic TC0938450-015CE Operating Instructions Manual

12 Configure the settings of the servers [Server]
IMPORTANT
•
When entering the host name for "FTP server address", it is necessary to configure the DNS settings on
the [Network] tab of the "Network" page. (section 13)
[User name]
Enter the user name (login name) to access the FTP server.

Available number of characters: 1 - 32 characters

Unavailable characters: " & : ; \

Default: None (blank)
[Password]
Enter the password to access the FTP server.

Available number of characters: 0 - 32 characters

Unavailable characters: " &

Default: None (blank)
[Control port]
Enter a control port number to be used for the FTP server.

Available port number: 1-65535

Default: 21
The following port numbers are unavailable since they are already in use.
20, 23, 25, 42, 53, 67, 68, 69, 80, 110, 123, 161, 162, 443, 995, 10669, 10670
[FTP mode]
Select "Passive" or "Active" for the FTP mode.
Normally, select "Passive". When it is impossible to connect after select "Passive", try to connect after selecting
"Active".

Default: Passive
12.3 Configure the settings relating to the NTP
server [NTP]
Click the [NTP] tab on the "Server" page. (section 6)
The settings relating to the NTP server such as the NTP server address, port number, etc. can be configured on
this page.
IMPORTANT

Use an NTP server when the more accurate time & date setting is required for the system operation.
[Time adjustment]
Select the time adjustment method from the following. Time adjusted by the selected method will be used as the
standard time of the unit.

Manual: Time set on the [Basic] tab on the "Basic" page will be used as the standard time of the unit.
54 Operating Instructions