8.1.1
Setting the focal length
Siemens Building Technologies
Fire Safety & Security Products
The factory setting for the focal lenth (back focus) is for a CS-mount lens (as
–
delivered).
Loosen the back focus lock screw (
1.
Set the IP camera to the back focus operating mode. See
2.
Section 10.5.7 Service configuration.
The lens aperture opens completely.
Turn the back focus dial (
3.
Tighten the screw (
4.
Connect the IP camera to the network using a network cable connected to the
5.
RJ-45 network jack (
).
2
) until the image is in focus.
1
) again carefully.
2
).
10
Assembly and setup
23
04.2006