Connection Of Speakers; R-Se9T/Dp-Se9/X-Se9 (En - Kenwood DP-SE9 Instruction Manual

12

3. Connection of speakers

Connect the speakers as shown in the figure.
Do not plug the power cord into a wall AC outlet until the connection has been completed.
1 Cord preparation.
2 Loosen.
3 Insert.
4 Secure.
Connection of banana plugs
1 Secure.
2 Insert.
• Sound will not be heard if
the speaker terminal is not
fully secured.
¶ Never short-circuit the + and – speaker cords.
The protection circuit will operate and no sound will
be put out.
¶ If the left and right speaker connections or the + and
– polarity are inverted, the sound will be unnatural
with unclear localization of musical instruments, etc.
Be sure to connect them without mistake.
Speaker (right)
(6-16 )
· ª
R-SE9T
SPEAKERS
( 6 - 16 )
+
R L
-
Super woofer (SW-500) (optional)
Extremely low frequency sound is played back powerfully.
This can be used with any type of playback.
Speaker (left)
(6-16 )
ª
SPEAKERS
( 6 - 16 )
R L
ANTENNA
FM75 GND AM
TAPE MD
REC
REC
SYSTEM
CONTROL
TAPE MD
PLAY
PLAY
CD AUX
IN
SUPER IN
R L R L
WOOFER
PRE OUT
SUPER
WOOFER
PRE OUT
System connection

R-SE9T/DP-SE9/X-SE9 (En)

·