Figure 7.12 Connection Of Ip Phones; Figure 7.13 Rj-45 Port Of Ethernet Connection Board - Samsung OfficeServ 7400 Installation Manual

CHAPTER 7. Ошибка! Стиль не определен.
Therefore, IP phones must be supported by the MGI/MGI64 board, which allows to access
LAN. Use the IP phone after the proper MMC setting.
MP40
Digital Phone
7.1.4.1 Connecting Boards to Ethernet
GWIM/GSIM/GLIMP/WIM/LIM/LIM-P/4DSL/MGI/MGI64/MP40/LP40/TEPRI2/SVMi-
20E board can be connected to Ethernet by using an Ethernet cable.
LIM Board - All ports(P1~P16)
GWIM Board - All ports(P1, P2, P3)
GSIM Board - All ports(P1~P10)
GLIMP Board - All ports(P1~P14)
Since all ports of GWIM and GSIM and Up Link port (P13, P14) of GLIMP only
support the SFP type of 1000Base SX/LX/TX, in order to connect the 10/100 BaseT
with the RJ45 Connector, use P1~P12 port of GLIMP.
4DSL Board - Up Link port(LAN)
MP40, LP40, MGI, MGI64, TEPRI2 and SVMi-20E Boards-LAN port
7-8
OfficeServ 7400
16DLI
MGI

Figure 7.12 Connection of IP Phones

Figure 7.13 RJ-45 Port of Ethernet Connection Board

Switching Hub
IP Phone
RJ-45 Port
© SAMSUNG Electronics Co., Ltd.