Bosch Classixx 1200 Instruction Manual page 46

Transport
Preparing and inserting the
transport bolts
46
Before transporting the washing machine
(e.g. when moving)
1.
Turn off the water tap(s).
2.
Release the water pressure in the supply hose(s)
(refer to Page 29).
3.
Drain any residual washing solution (refer to
Page 28).
4.
Disconnect the washing machine from the mains.
5.
Dismantle the supply and drainage hoses.
6.
Remove the covers.
7.
Pull the bolt out of the sleeve until the end of the
bolt is flush with the end of the sleeve.
8.
Insert and tighten the transport bolts.
The lug on the washer must be located in the
groove in the rear panel of the housing.
i Having transported the appliance and ensured
proper installation and connection, after removing
the transport bolts first allow the b Drain
programme to run through before starting the first
wash programme.