System Programming And Diagnosis With Personal Computer - Panasonic KX-TD816 Features Manual

System Programming and Diagnosis with Personal
Computer
Description
This system can be programmed and administered using a personal computer. The Serial
Interface/Remote Programming & Diagnosis Manual and its floppy disk are required to
perform this feature. The KX-TD816 cannot perform the diagnosis. There are two
programming methods:
Warning
The dealer should take care with the system password:
a)
Please thoroughly instruct the importance of the password and the dangers involved to
the customer.
b)
Please maintain the secrecy of the password.
If discovered by a "hacker", he can proceed to commit toll fraud with the PBX.
c) Please change the password often.
d)
We strongly recommend that you set the system password to 7 digits for maximum
protection against "hackers".
e)
We strongly recommend that the dealer backs up the system data after the password is
changed. In the event the password is forgotten, it can be recovered from the system
data. If the system data is not available, regrettably, the system must be Default Cleared
and the system must be programmed from scratch.
On-Site Programming
By connecting a personal computer (PC) to your system, system programming and
maintenance can be performed locally. There are two ways available to perform the above:
(Method 1.) Using the Serial Interface (RS-232C) port
Connect the PC to the Serial Interface (RS-232C) port provided. The main unit has an Serial
Interface (RS-232C) port which can be used for either system administration or Station
Message Detail Recording (SMDR).
(Method 2.) Using a modem
Install the optional Remote Card. Connect the PC to an extension jack. Assign the floating
number of the modem in System Programming. Dial this number from the PC.
Remote Programming
You can perform system programming and maintenance from a remote site using a PC. Install
the Remote Card and assign the floating number of the modem in System Programming.
Starting system administration from a remote location can be done in the following ways.
• Call an extension (probably the Operator) from a remote location and request a transfer
to the modem.
• Dial the floating number of the modem using the Direct Inward System Access (DISA)
feature.
• Assign the modem as the destination of the Direct In Lines (DIL) 1:1 feature.
Features Guide
General Features
243