Heat shield screws
5. To remove the upper heat shield remove two screws
from the bottom and two screws from the top, then
drop front of the shield down into the drawer area
and pull it out the front.
Heat shield screws from bottom
Heat shield screws from top
Note:
The upper heat shield has four screws driven
through the bottom center. These screws are used as
spacers and if the shield is replaced must be installed
on the new shield.
Fan cover (convection and speed bake models):
1. Disconnect power from the range.
2. Remove the two screws holding the cover to the oven
liner and remove the cover.
Fan cover screws
Fan blade (convection and speed bake models):
1. Disconnect power from the range.
2. Remove the fan cover.
3. Hold the fan blade and remove the nut by turning
clockwise with a 1/2" wrench.
4. With the nut removed pull the fan blade off the shaft.
Removing fan blade
Removing assist element (convection models):
1. Disconnect power from the range.
Assist element screws
105