Motorola ET1 Integrator Manual page 58

4 - 12 ET1 Enterprise Tablet Integrator Guide
•
Code93
•
Length1 - Use to set decode lengths (default - 0). See
information.
•
Length2 - Use to set decode lengths (default - 55). See
information.
•
Redundancy - Sets the reader to read the bar code twice before accepting data. A check in the
checkbox indicates that redundancy is enabled (default - disabled).
•
Discrete 2 of 5
•
Length1 - Use to set decode lengths (default - 0). See
information.
•
Length2 - Use to set decode lengths (default - 14). See
information.
•
Redundancy - Sets the reader to read the bar code twice before accepting data. A check in the
checkbox indicates that redundancy is enabled (default - enabled).
•
Code11
•
Length1 - Use to set decode lengths (default - 4). See
information.
•
Length2 - Use to set decode lengths (default - 55). See
information.
•
Redundancy - Sets the reader to read the bar code twice before accepting data. A check in the
checkbox indicates that redundancy is enabled (default - enabled).
•
Verify Check Digit - Check the integrity of all Code 11 symbols to verify that the data complies with
the specified check digit algorithm. This selects the check digit mechanism for the decoded Code 11
bar code.
• No Check Digit - Do not verify check digit.
• 1 Check Digit - Bar code contains one check digit (default).
• 2 Check Digits - bar code contains two check digits.
•
Report Check DIgit - Transmit Code 11 data with or without the check digit. A check in the checkbox
indicates to send Code 11 data with check digit (default - disabled).
•
Webcode
•
Webcode Subtype - Enables the decoding of the GT Webcode subtype. A check in the checkbox
indicates that the option is enabled (default - disabled).
•
UPCE1
•
Report Check Digit - The check digit is the last character of the symbol used to verify the integrity of
the data. Enables or disables this option. A check in the checkbox indicates that the option is enabled
(default - disabled).
•
Preamble - Preamble characters are part of the UPC symbol consisting of Country Code and System
Character. There are three options for transmitting a UPCE1 preamble:
• Preamble Sys Char - Transmit System Character only.
• Preamble Country and Sys Char - Transmit System Character and Country Code ("0" for USA).
• Preamble None - Transmit no preamble (default).
Select the appropriate option to match the host system.
•
Convert UPCE1 To UPCA - Enable this to convert UPCE1 decoded data to UPC-A format before
transmission. After conversion, the data follows UPC-A format and is affected by UPC-A programming
Decode Lengths on page 4-13
Decode Lengths on page 4-13
Decode Lengths on page 4-13
Decode Lengths on page 4-13
Decode Lengths on page 4-13
Decode Lengths on page 4-13
for more
for more
for more
for more
for more
for more