Creating Labels For The Deskset Buttons; Wall Mounting - Motorola MC3000 Operating And Installation Manual

Installation

Creating Labels for the Deskset Buttons

The lower the resistance value, the higher the gain. The default value for R12 (when
connecting the deskset to a Digital Junction Box) is approximately 1.5 K ohms for
80mV .
RMS
Note: When connected directly to the radio without other desksets in parallel, no
adjustment to R12 is required.
Creating Labels for the Deskset Buttons
The MC3000 Digital Deskset requires the Labels software program to print labels for the
deskset's buttons.
The software installation diskette includes a "Labels Program". The labels program is a
Windows application that allows you to produce and print labels for the operator module
buttons on the MC3000 Digital Deskset console. For information on how to use the
"Labels" program, see Appendix A.
To install the Labels Program:
1. Ensure all other software programs, currently open on your computer, are closed.
Insert the installation diskette into the diskette drive of your computer.
2. Follow the instructions as they appear on your computer screen and click the Next
button until you get to the screen where both program titles appear on your computer
screen.
3. Check the Label program check box.
4. Click the Next button. The installation process will begin. If you wish to cancel the
installation, click the Cancel button.
5. Follow the instructions as they appear on your computer screen.
6. When you are finished, click on the Labels.exe file in the destination folder (default
c:\Program Files\Motorola) to start the program.

Wall Mounting

To wall mount:
1. Open the unit as described in the "Opening Deskset" on page 2-6.
2. After making the required connections, turn the front housing 180 degrees and place it
into the back housing so the bulk of the combined housing is at the bottom of the of
the wall mounted configuration.
Note: In the desk mounted housing configuration, the bulk of the combined housing is
to the top so the unit is slanted toward the operator for ease of use. The opposite
housing configuration is required to hold the handset in the cradle for the wall
mounted configuration.
3. Hold the back and front sides of the housing together, turn the deskset face-down.
4. Reattach the four screws in each corner of the back housing.
2-22
MC3000 Digital Deskset Operator and Installation Manual
(6880309L15-A)