Entering Gateway Mode; Standby Mode; Forwarding A Group Call; Setting Monitor Option - Motorola MTM5400 Feature User Manual

Feature User Guide

3.8.1 Entering Gateway Mode

Procedure Steps
1 From the home screen, press Optns.
2 Select Gateway Mode.

3.8.2 Standby Mode

Your radio enters Standby mode if there is another Gateway on the same DMO frequency. Gateway icon flashes and
no transmission is forwarded through the gateway. To exit Standby Mode you can:
• choose another DMO talkgroup
• wait untill the other gateway is out of coverage and is no longer present on that DMO talkgroup

3.8.3 Forwarding a Group Call

Your radio shows the source and destination talkgroup of the Group call.

3.8.4 Setting Monitor Option

Procedure Steps
1 From the home screen, press Optns.
2 Press Config and Select one of the following:
• Off — Audio of the calls are not routed to the speakers of the gateway.
• Receive Only — Audio of the calls are routed to the speakers of the gateway.

3.8.5 Emergency Calls in Gateway Mode

Press the EMERGENCY button to enter the TMO Emergency mode and start an Emergency Group call. Check with
your service provider if the Emergency Group call starts on a tactical or non-tactical talkgroup. If the radio that is in
the Gateway mode receives an Emergency Group call, it forwards it to the respective TMO/DMO talkgroup that
is currently switched to.
3-18 -