Step 11. Run The Philips Upgrade Wizard Again - Philips IntelliVue Telemetry System Infrastructure Installation And Service Manual

Standard APs will list Remote Antennas as Not Present. Core APs will provide
general status of connected Remote Antennas.
4. Click SAVE and then verify the AP Configuration settings.

Step 11. Run the Philips Upgrade Wizard Again.

Run the Philips Upgrade Wizard again to check and verify final APC and AP
configurations, and fix any errors as needed. If any configuration modifications are
made, run the Philips Upgrade Wizard again.
Caution Close the APC web interface before running the Philips Upgrade Wizard. Do not add
components to or remove components from the IntelliVue Telemetry System while
the wizard is running.
Follow these steps to upgrade ITS Access Point Controllers and Access Points using
the Philips Upgrade Wizard:
Philips Upgrade Wizard:
1. Run the Philips Upgrade Wizard by double-clicking the file:
C:\TelemetryUpgrader\upgrader.exe
The Upgrade Wizard splash screen (Figure 3-25) appears.
2. Click Next> to continue.
The APC/AP firmware selection screen (Figure 3-18) appears.
3. Complete the settings on the APC/AP firmware selection screen:
a) Click ... and then browse to the directory (e.g.,
b) Specify what type of APs you have installed by marking the appropriate radio
IntelliVue Telemetry System Infrastructure Installation and Service Guide
Figure 3-25: Upgrade Wizard Splash Screen
in which you have installed the APC and AP firmware
and APC Images\)
files.
button, 1.4 GHz Smart Hopping or 2.4 GHz Smart Hopping.
Step 11. Run the Philips Upgrade Wizard Again.
C:\TelemetryUpgrader\AP
3-41