Table of Contents
Advertisement
be configured correctly in order to control the camera with your control device.
.
CameralD
(default l)
.
Protocol
(default P/D. i.e., Pelco D)
.
Auto focus mode (defaultAUTO)
Depending on the contnol device and the application, other camera parameters (e.g.,
motion detection mode) may also need to be configured.
Refer to the manual of yow control
device as well as the manual for your camera for details.
6. Try to control the camera through the control device. Repeat step 4 if necessary.
2.4.3 Mount/Dismount Lower Dome
Before mounting the lower dome, make sure that
'
Camera ID, protocol, and baud rate are correctly set up with dipswitches.
.
Camera lens cover is removed.
.
Camera is configured properly.
To keep fingerprints and scratches from distorting the lower dome, wear the provided
gloves when handling the lower dome. To mount the lower dome, carefully line the screw holes on
the back box up with the screws on the lower dome ring and tighten the screws (refer to the figure
below). Do not remove the plastic wrap on the lower dome until all steps are done.
Do the reverse for dismounting.
2.4.4 Mount to a Support
Send wires through the support and tighten the mounting screws on the support, or follow
the manual of the support. If using a support provided by us, refer to the following chart for
support mounting.
2.4.5 Install ttre Entire Unit
Notc: Since thc horizontel rotation range of the YIZ umit is not 360", please identify and
avoid the blind angle position before insbll
tfre unit.
For outdoor model, the blind
angle is at the support (bracket) position. For indoor model, the blind angle position is
shown on the stickeron
the upper dome housing.
Always install the unit in a place with enough holding force to support the weight of the
unit The required minimum holding force is five times the total weight of the unit and the support.
Due to the fact that installation of an entire unit is subject to local administrative regulations, we
*:lnrlit
Advertisement
Table of Contents
