Panasonic AG-CPD15P Operating Instructions Manual page 91

Administrator Setup
Remove the USB memory device
and perform "Operations on a second
recorder" starting from step 1.
Replace the USB memory device
and perform "Operations on a second
recorder" starting from step 1.
Perform "Operations on this recorder"
starting from step 1.
Using a P2 card
1. Use a PC to copy the configuration
∗
f i l e c r e a t e d i n s t e p 3 o f
1
"Operations on this recorder" from
the USB memory device to the root
directory on a P2 card.
2. Open the P2 card slot on the
second recorder and insert a
P2 card in the slot1
3. With the P2 card slot cover
open, keep pressing the [REC]
button on the second recorder
until the [READY] or [BUSY]
lamp starts to flash (about 10
seconds or more).
The configuration file
Loading takes between 20 to 50
seconds. The [READY]
when the file has been successfully
loaded.
4. Press the [STOP] button.
The second recorder reboots and
will now run using the same settings
as this recorder.
∗1 The configuration file is the file
with the ".CFG" extension. The
configuration file contains all
information set on this recorder
excluding the following data.
• AG-CPD15 Operating Time
• FAN Operating Time
• CAM1 Operating Time
• AG-RCP30 Operating Time
• LCD Lighting Time
• AG-CPD15 Version
• BIOS Creation Date
• Microcontroller Version
• AG-RCP30 Version
• Last errors
(continued)
∗2 Don't insert a P2 card in the slot2
∗3 The following lamp states indicate
∗
.
2
∗
1 is loaded.
∗
lamp lights
3
since the menu settings are not
copied.
that an error has occurred.
[BUSY] lamp fast blinking:
This indicates that an error occurred
during configuration file
administrator authentication.
• If a configuration file
occurred, the following are probable
causes.
- The configuration file is missing.
- There are multiple configuration files.
- The configuration file is corrupted.
• If an administrator authentication
error occurred, administrator setup
has been made on the second
recorder. Use a PC to copy the
administrator's officer data to the
\WIDKEY on the USB memory
device. For details regarding text
files containing administrator's
officer data, see "Text Files Used
with the Recorder" on pages 43
- 46. Connect the USB memory
device to the second recorder and
perform step 3 of "Operations on a
second recorder" again.
[READY] lamp goes off:
This indicates that the data could
not be correctly loaded. Perform the
operations below in the stated order.
If the [READY] lamp still does not
light, consult your supplier.
Perform "Operations on a second
recorder" starting from step 1.
Perform "Operations on this
recorder" starting from step 1.
∗
1 check or
∗
check error
1
91