Panasonic AG-CPD15P Operating Instructions Manual page 84

Administrator Setup
Connection of Radar
Use this function to specify the radar
gun connection port.
VPU : when connected to this unit
OFF : when not connected
Notes:
• This unit has no function for
calculating the speed of the target
vehicle from the moving own
vehicle.
• No distinction is made between
the speed of an approaching
target vehicle and a receding one.
• Some radar guns come with
a function for setting conditions
that enable correct measurement
of target vehicle speed. Use
this function according to the
instructions in the Operating
Instructions of the radar gun.
• Error messages appear when the
radar gun is operating abnormally.
GPS
Connection of GPS
Use this function to select GPS data
source.
VPU : Uses GPS data from the GPS
module attached to this unit.
PC : Uses GPS data from the PC.
OFF : Does not use GPS data.
Collection Time
Use this function to set the time to
collect GPS data.
Setting (sec.) : 1, 2, 5, 10
∗ Find and set the pulse number, based on the outside diameter of the tire and
the number of pulses per tire revolution, using the "Vehicle Speed Pulse Setting
Table". Confirm the set value is correct by actually driving the vehicle. The
outside diameter is the diameter of the tire from its outer edge, not its rim size.
84
(continued)
Geodetic System
Use this function to set the geodetic
system. Japanese maps use one
of two geodetic systems. Adjust the
system to the map you are using.
This setting is available only when
the TimeZone is set to "Asia Tokyo".
WGS84 : World Geodetic System
TOKYO : Japan Geodetic System (old)
Speedpulse
Speedpulse at Std Speed
Setting the speed in MPH units :
Sets the number of 1-second pulses
at 40 M/h. (Refer to the "Vehicle
Speed Pulse Setting Table (at 40
mph)" on pages 106 and 107.)
Setting : 5 - 400
Setting the speed in KPH units :
Sets the number of 1-second pulses
at 60 km/h. (Refer to the "Vehicle
Speed Pulse Setting Table (at 60
kph)" on pages 108 and 109.)
Setting : 5 - 400
∗