Mounting on Concrete or Mortar Wall
WARNING
•
Only use the wall-mounting equipment (screws, washers) included with the PBX.
•
Be careful not to drop any components. Dropping components may damage them or cause an
injury.
CAUTION
•
When driving the screws into the wall, be careful to avoid touching any metal laths, wire laths or metal
plates in the wall.
1.
Place the reference for wall mounting (on the following page) on the wall to mark the two screw positions.
2.
Install two anchor plugs (user-supplied) in the wall.
Anchor Plug
Hammer
3.
Install the screws (included) in the wall.
Drive the screw
to this position.
Document Version 2010-11
110 mm
(4-5/16 in)
8 mm
(5/16 in)
30 mm
(1-3/16 in)
2.2.10 Wall Mounting (AC Adaptor)
Installation Manual
59