Panasonic KX-HCM110A Installation Manual

Installation

Network Camera

KX-HCM110A
Model No.

IMPORTANT SAFETY INSTRUCTIONS

When using this unit, basic safety precautions should always be
followed to reduce the risk of fire, electric shock, or personal injury.
1. Read and understand all instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. After taking away the sand or the dust on the lens cover, wipe the lens
cover with a dry cloth.
6. Do not block any ventilation openings. Install in accordance with the
manufacturer's instructions.
7. Do not install near any heat sources such as radiators, heat registers,
stoves, or other devices (including amplifiers) that produce heat.
8. Protect the AC adaptor cord and AC cord from being walked on or
pinched particularly at plugs, convenience receptacles, and the point
where they exit from the unit.
9. The AC cord is used as the main disconnect device, ensure that the
socket-outlet is located/installed near the equipment and is easily
accessible.
10. Only use attachments/accessories such as stand specified by the
manufacturer.
11. Do not touch the unit or the AC adaptor cord and AC cord during
lightning storms.
12. Unplug the unit when unused for long periods of time.
13. Refer all servicing to qualified service personnel. Servicing is required
when the unit has been damaged in any way, such as when the AC
adaptor, AC cord or plug is damaged, the unit does not operate
normally, or after the unit has been dropped.
14. The camera is intended for indoor use only. Prolonged exposure to
direct sunlight or halogen light may damage CMOS sensor.
15. Unplug this unit from power outlets if it emits smoke, an abnormal
smell or makes unusual noise. These conditions can cause fire or
electric shock. Confirm that smoke has stopped and contact an
authorized service center.
SAVE THESE INSTRUCTIONS

FCC and Other Information

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
Environment:
Do not install the camera where the temperature is less than 0 ˚C (+32 ˚F) or greater than +40 ˚C (+104 ˚F). Allow 10 cm (4 inches) clearance around
the unit for proper ventilation. Avoid excessive smoke, dust, mechanical vibration, shock, or direct sunlight.
Routine care:
Wipe the unit with a soft cloth. Do not use benzine, thinner, or any abrasive powder.
When you leave the unit unused for a long period of time, disconnect the AC adaptor cord from the outlet.
If you have any problems:
Consult an authorized Panasonic Factory Service Center.
CAUTION:
Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this device.
No responsibility will be taken by our company with respect to consequences
resulting from the use, damage or both of the camera.
CR Coin Cell Lithium Battery Information:
This product contains a CR Coin Cell Lithium Battery which contains Perchlorate Material - special handling may apply.
See www.dtsc.ca.gov/hazardouswaste/perchlorate.
Audio and Video Recording Notice:
PLEASE NOTE that under certain circumstances, audio/video recording may be PROHIBITED by law. This device should be used only in compliance with
all applicable federal, state and local statutes.
2005 Panasonic Communications Co., Ltd. All Rights Reserved.
PSQX3768ZB
KK0305YT1056
Please read this manual before using and save this manual for future
reference.
Panasonic Network Camera Website: http://www.panasonic.com/netcam for
customers in the USA or Puerto Rico
How to Use This Documentation
The camera includes the following 4 manual types.
Installation (This manual) (Included on the Setup CD-ROM)
•
This manual provides explanations for items included with the camera.
Getting Started (Included on the Setup CD-ROM)
•
Getting Started provides explanations for the initial configuration and
the ways of camera mount. The Getting Started helps you to
easily configure the camera.
Operating Instructions (Included on the Setup CD-ROM)
•
Operating Instructions explains about operations, settings, features and
the cleaning method when using the camera.
Troubleshooting (Included on the Setup CD-ROM)
•
Troubleshooting provides explanations for troubleshooting tips.
Trademarks
• Microsoft and Windows are either registered trademarks or trademarks of
Microsoft Corporation in the United States and/or other countries.
• Pentium is a trademark or registered trademark of Intel Corporation or its
subsidiaries in the United States and other countries.
• All other trademarks identified herein are the property of their respective
owners.
• This software is based in part on the work of the Independent JPEG Group.
Abbreviations
• UPnP is the abbreviation for "Universal Plug and Play".
• "Network Camera" is called "Camera" in this Installation.