Step 2 - Connecting Your Wired Devices - Bosch Mastertech M-VCI Installation Manual

7 | Installation Steps | Step 2
f Done!
At this point, the router will reboot
and you will lose communication,
this is normal. Disconnect the
computer from the NETGEAR
Router at this time.
Step 2 - Connecting Your
Wired Devices "Special
Instruction for Type I"
Using an Ethernet cable,
f
connect one end into the LAN
port on the NETGEAR Router.
Connect the other end to one
f
of the following:
– A LAN port on your pre-
existing router or,
– An open network drop that
is connected to your pre-
existing network.
f Provide AC power to the
NETGEAR Router
Robert Bosch LLC M-VCI – NETGEAR® Router Installation Guide Index | Version 1.0 | June 2009
Not used
For additional wired To existing
devices (if needed) router port
This shows a typical connection to
an existing router.
Connected
You are now finished with Step 2,
proceed to Step 3.
Step 2 - Connecting Your
Wired Devices "Special
Instruction for Type II"
Important: Use the same PC that
was originally connected to the
modem for these steps.
Connect the computer to the
f
LAN port of the NETGEAR
Router
Reboot the computer (to
f
renew the NETGEAR Smart
Wizard IP Address)
Open your Web Browser
f
Enter http://192.168.10.1 into
f
your browser address bar and
Press: <Enter>
Enter User ID and Password
f
– User ID: admin
– Password: Bosch_VCI_AP
– Click: OK
Caution! Do not connect the
router to the cable/DSLmodem at
this time.
M-VCI – NETGEAR® Router Installation Guide Index | Version 1.0 | June 2009
Installation Steps | Step 2 | 8
Step 2 - Connecting Your
Wired Devices "Special
Instruction for Type II"
(Setting NETGEAR Router
configuration)
Click: Basic Settings
f
Step 2 - Connecting Your
Wired Devices "Special
Instruction for Type II"
(Setting NETGEAR router
MAC Address)
f Click: Use Computer MAC
address
Click: Apply
f
Wait for the router to apply
f
settings
Robert Bosch LLC