Figure 2-8. Removing The Lcd Module - HP OmniBook 7100 Service Manual

Screw, M2.5×8mm
Screw, M2.5×6mm (4)
Screw, M2.5×3mm
Inverter PCA
Hinge
Reassembly Notes
• Make sure the connector on the main display cable seats correctly on the LCD connector.
• Install the LCD shield and three display brackets on the LCD module, then install the complete
assembly onto the posts at the top of the display case. Lower the assembly into the case.
• Route the LCD wires under the main display cable near the right hinge.
HP OmniBook 7100

Figure 2-8. Removing the LCD Module

Screw cover
Display bezel
Screw, M2×3mm (4)
Display brackets (3)
LCD module
Display cable
LCD shield
End cap (2)
Removal and Replacement 2-13