Projection From The Projector; Installing The Digitizer - Hitachi StarBoardLink EZ User Manual

StarBoardLink EZ

2.3.2 Projection from the Projector

Project the computer screen using the projector.
To install the StarBoard, ensure the following clearance is maintained around the projection area.
However, the StarBoard detectable sizes are as shown below.
(Aspect ratio 4:3) 45-77 inches
(Aspect ratio 16:10) 45-90 inches
3cm (1inch)

2.3.3 Installing the Digitizer

・Installing with Magnets
Align the center of the digitizer with the center of the projection area, 12cm (5 inches) above the
projection area, and install so it is parallel with the edge of the projection area.
Digitizer
24cm (10inch)
Projection Area
3cm (1inch)
12cm (5inch)
Projection Area
After installing the digitizer, check to make
sure does not slide down due to its own weight,
and that it is securely installed.
2-4
Assembly and Setup
3cm (1inch)
English