4-40 Configuring Your Server
1.
See the section "Preparing for Installation and Removal" as described in Chapter 9 of this
guide to prepare.
2.
Remove the left side cover (see Chapter 9).
3.
Locate the position of the RAID configuration jumper on the mother board as shown
below.
NOTES:
The RAID configuration jumper switch is factory-set to "RAID
disabled".
If you are using an Optional RAID Controller, set the RAID
configuration jumper switch to the position "RAID disabled".
4.
Install the left side cover removed in Step 2.
Then, configure the RAID system by using the LSI Software RAID Configuration Utility.
RAID configuration
RAID
jumper switch
disabled
RAID
enabled