HP A10500 Series Installation Manual page 16

Figure 9 Installing cable management brackets on an A10504
(1) Attach the cable management bracket to the
chassis
(3) Screws for attaching the cable management
bracket to the chassis
Installing mounting brackets
Before installing the switch to the rack, install the mounting brackets to the chassis. Marks L and R are
printed inside the mounting brackets to distinguish between the left and right mounting brackets. To
install the mounting brackets, face the front of the switch, and mount the left and right mounting brackets
to the two sides of the switch, as shown in
Figure 10 Installing the mounting brackets (A10508)
(1) Screws for attaching the mounting brackets to the chassis
(3) Signal cable management brackets
(2) Screw holes for installing the cable management
bracket
(4) Power cable management bracket (installed at
the lower part of the chassis)
Figure 12.
(2) Mounting brackets
11