Step 2: Preparing For Network Connection; Step 3: Easy Setup - Sony BDP-S1200 Operating Instructions Manual

Step 2: Preparing for
Network Connection
If you are not going to connect the player
to a network, proceed to "Step 3: Easy
Setup" (page 16).
Wired Setup
Use a LAN cable to connect to the LAN
(100) terminal on the player.
LAN cable
(not supplied)
Broadband
router
z
The use of a shielded and straight interface
cable (LAN cable) is recommended.
Wireless Setup (BDP-S3200/
S5200 only)
Use the wireless LAN that is built into
the player.
LAN cable (not supplied)
Wireless LAN
router
16
ADSL modem/ Internet
Cable modem
ADSL modem/ Internet
Cable modem

Step 3: Easy Setup

When turned on for the first time
Wait for a short while before the
player turns on and starts [Easy
Initial Settings].
1
Insert two R03 (size AAA)
batteries by matching the 3 and
# ends on the batteries to the
markings inside the battery
compartment of the remote.
2
Connect the supplied AC adaptor
and AC power cord (mains lead)
in the numeric order shown
below. When removing them, do
so in reverse order.
1
to DC IN 12 V
AC adaptor (supplied)
2
AC power cord (mains lead)
(supplied)
3
to mains