Msk Ptt Id; Power On Text; Data Programming (Pc Mode); Mode - Kenwood TK-790 Service Manual

• Emergency Mode Type
Speaker mute on or off in the emergency mode.
• Emergency Type
Select an Emergency code format from DTMF, MSK, ANI
board or OFF (Disabled).
• Emergency DTMF ID
The emergency DTMF ID code when you select DTMF in
the emergency type.
• Emergency Call Fleet
The emergency fleet number when you select MSK in
the emergency type.
• Emergency Call ID
The ID number when you select MSK in the above emer-
gency type.

39. MSK PTT ID

• Side Tone
A tone to notify the voice transmission is allowed after
sending the MSK PTT ID (Connect ID).
• Fleet (Own)
• ID (Own)
Configure the Fleet/ID of the MSK PTT ID (Fleet Sync
Format).
• Data TX Mod. Delay
Delay time of transmitting the MSK ID after the trans-
ceiver enters the transmission mode.

40. Power On Text

To display the Power on text for approximately 2 seconds
when the transceiver is turned on.

41. Data Programming (PC Mode)

41-1. Preparation and Connection
TK-790 transceiver is programmed by using a personal
computer, programming interface cable KPG-43, and pro-
gramming software KPG-44D.
The programming software can be used with an IBM-PC
or compatible machine. Figure 1 shows the setup for pro-
gramming.
OPERATING FEATURES
41-2. Programming Interface Cable KPG-43 Description
puter. It has a circuit in its D-sub 25 pin connector case that
converts RS-232C logic level to TTL level.
connector and RS-232C serial port of computer.
41-3. Programming Software KPG-44D Description
plied on a 3.5" floppy disk. This software runs under MS-
DOS version 3.1 or later on an IBM-PC/XT, AT, or PS2 or
compatible machine.
on the screen. The programmed or edited data can be
printed out. It is also possible to tune the transceiver.
harddisk first then use it.

42. Mode

Firmware programming mode
*
TK-790/
The KPG-43 is required to interface TK-790 to the com-
KPG-43 is used to connect between TK-790 microphone
KPG-44D is the programming software for TK-790 sup-
The data can be input to or read from TK-790 and edited
We recommend that install KPG-44D for example to
KPG-44D instruction manual part No. : B62-1011-XX.
IBM-PC
KPG-44D
Fig. 1
User mode
PC mode
Panel test mode
Clone mode
: Single band only
( B ) /H ( B
KPG-43
PC programming mode
* PC test mode
* PC tuning mode
Panel tune mode
All clone mode
Group clone mode
19200 bps
38400 bps
[PF4]
57600 bps
115200 bps
)
13