Husqvarna Rider Pro 18 AWD Operator's Manual page 41

6. Remove the clamp on the hydraulic pipes,
located under the fan. Loosen the pipe
connections from the pump slightly, bend the
hydraulic pipes down and pull the cooling fan out
backwards.
7. Pull the belt off of the pump's pulley.
8. Pull the pump belt off of the engine's pulley and
move it under the engine belt pulleys.
9. Pull out the pump belt through the opening
under the pivot bearing and past the belt
tensioner's disc.
Assembly
10. Pull the pump belt through the opening under
the pivot bearing and on the outside past the
belt tensioner's disc.
11. Fit the pump belt on the engine's pulley, move it
under the engine belt pulleys.
12. Fit the belt on the pump's pulley.
13. Fit the cooling fan.
14.Tighten the cooling fan nut. Counter hold using a
punch in one of the holes on the underside of
the fan when the nut is tightened.
15.Refit the clamp on the hydraulic pipes, located
under the fan. Tighten the pipe connections on
the pump.
16.Check that the centre belt is fitted correctly on its
front pulley and fit the centre belt on the engine's
pulley.
MAINTENANCE
8009-641
8009-640
8009-640
8009-641
8009-726
39
English –