Inserting The Battery - Silvercrest DV-5100HD User Manual

DV-5100HD
The status indicator of the charging cradle will light orange whilst
the battery is charging. When the charging process is completed,
the status indicator will light green. Now you can insert the
rechargeable battery into the camcorder. Depending on the charge
level, the charging cycle can take up to 2 hours.
If, after inserting the rechargeable battery, the
indicator remains green, this means the rechargeable
battery is already charged or it is not correctly
inserted. In this case, check the polarity.

Inserting the Battery

When the battery is fully charged, insert it into the camcorder as
below. To do this, open the battery compartment by gently pushing
on the marking and sliding it outwards (see figure 1).
1
3
Next insert the battery into the camera, as shown in figure 2. Close
the battery compartment by placing the cover on it and sliding it
inwards until it clicks into place (see figures 3 and 4).
You may optionally power the camcorder by using conventional
batteries. To do so use four AAA-sized batteries, 1.5V. Insert the
conventional batteries instead of the rechargeable battery into the
battery compartment. Always pay attention to the polarity. The
polarity is indicated with the symbols + and – on the batteries and
on the inside of the battery compartment cover.
2
4
Introduction
English - 19