Assembly - Husqvarna 115 149727 R01 Operator And Parts Manual

1
INSTALLING DRIVE PULLEY
1. Remove the discharge chute from the deck. (Deck
configuration will vary by size and model)
2. Lower deck to the lowest cutting position.
3. To prevent interference with the new belt shield,
reverse the bolt/nut assembly on the rear of the
deck height adjustment plate.
4. Remove the right hand (discharge side) belt cover
from the deck.
Reverse rear
bolt/nut

assembly

Discharge Chute
5. Remove the bolt securing the right hand deck
pulley to the spindle.
6. Replace right blade shaft with new, longer shaft.
The existing drive pulley and key will fit on the new
shaft. Install blower drive pulley with the raised
portion of pulley hub down. Slide spacer inside
new pulley. Add key to new pulley.
7. Remove two rear bolts from spindle and place belt
shield standoff where the two bolts were removed.
Replace bolts and tighten.
8
ASSEMBLY
8. Use heavy washer and bolt supplied in kit to attach
pulley to spindle. Torque to 55-75 ft/lbs.
9. Reinstall the deck belt.
Deck Height
Adjustment
Belt Cover
Belt Shield
Standoff
2
MOUNTING BLOWER ASSEMBLY
1. Install the front mount bracket to the deck with the
pin and hairpin cotter supplied with the kit.
Outer Pulley Cover
New Heavy Washer
Drive Pulley
Spacer
Key
Hairpin Cotter
New Bolt
Spindle
Replacement Shaft
Pin