6
TRIMMING MIDDLE CHUTE
1. Using the hacksaw, trim along the dashed line.
2. Locate the middle chute, flat washer, hood latch,
weld nut, lock washer and machine screw from kit.
3. Install in the appropriate hole at the upper end of
the middle chute, according to deck size.
Machine Screw
Hood Latch
Weld Nut
Lock Washer
Flat Washer
Latch Location
7
INSTALLING MIDDLE CHUTE
1. Place middle chute over the top end of the blower
assembly.
2. Latch middle chute to blower assembly.
10
ASSEMBLY
Trim Line
Middle Chute
Blower Assembly
7
INSTALLING BAGGER MOUNT
1.
Using hardware provided in kit, attach support
mount to unit.
2.
Attach hanger bracket to support mount. Do not
fully tighten nuts at this time.
Support Mount
Hanger Bracket
3.
Secure rear end of support straps to outside of
hanger assembly. Set reinforcement plates to the
outside of the tank brackets and fasten front end
of support strap to tank bracket and reinforcment
plate with round head bolt. Secure front end
of reinforcement plate to tank bracket with hex
bolt. Fully secure all mounting hardware. See
illustration.
NOTE: Rear guard hole may need to be drilled out
to
/
" if kit hardware is too large.
5
16
Hex Bolt Placement
Round Head
Bolt Placement
Support Straps
Reinforcement Plate