Table of Contents
Advertisement
Digital Multiplexer
When desiring to see automatic sequential conversion screen
The automatic sequential conversion mode operates in the LIVE screen status and consists of the follow-
ing 2 cases:
The FULL screen is converted if pressing the "SEQUENCE" button in the FULL screen status. The screen
on the bottom right side is converted if pressing the "SEQUENCE" button in the 4, 9-division screen sta-
tus. The LED of the "SEQUENCE" button turns on for both cases.
The conversion time in the automatic sequential conversion mode is set in the "SEQUENCE.." of the "2.
MON OUT SET" in case of the PRPGRAM mode for the FULL screen and the time to set up is 00sec ~
30sec. The screen set to 00sec is skipped. The screen on the right bottom is switched in the interval of a
second for the 4, 9-division screen.
Method to release
- Press the "SEQUENCE" button once again. In this case the LED turns off. And then it stops on the
screen currently seen.
The "SEQUENCE" button does not operate in the following cases:
- In replay mode or TRIPLEX mode
- In the division screen mode other than 4, 9-division screen
- In setting of program mode
- In displaying ALARM LIST on screen
- During ZOOM operation
- During ALARM operation
4-3
Advertisement
Table of Contents
