EPSON Stylus Photo 890/1280/1290
9.
Removing 1 screw (CBP, 3x8) securing TRAY, ABSORBER ASSEMBLY to the
right part of the printer mechanism.
10. Remove SPACER, TRAY securing TRAY, ABSORBER to the left side of the
printer mechanism, and then remove TRAY, ABSORBER by moving it
downward.
11. Remove ABSORBER, WASTE INK, LARGE/ SMALL from TRAY,
ABSORBER.
n
When installing TRAY, ABSORBER ASSEMBLY to the
C A U T I O N
printer mechanism, make sure they are securely jointed with
SPACER, TRAY. Refer to Figure 4-12.
n
Be careful not to damage SCALE, PF, (loop scale) when
installing SPACER, TRAY.
n
When installing ABSORBER ASSEMBLY, make sure the Ink
Tube is correctly placed in the ABSORBER ASSEMBLY. If
not, it may cause an ink leakage.
n
If you replace TRAY, ABSORBER ASSEMBLY, be sure to
A D J U S T M E N T
R E Q U I R E D
perform the Waste ink counter reset operation. (Refer to
Chapter.)
n
When installing TRAY, ABSORBER ASSEMBLY to the
printer mechanism, make sure it securely joins to FRAME,
RIGHT by its hook in the right.
DISASSEMBLY AND ASSEMBLY
Disassembly Procedures
Revision C
90